Great gun and a great read, thanks Brownie.

Thanks for the thoughts folks. It's off to a gunsmith for internals replacements. It'll be my sleep milspec on the outside with nub sights and a race car internally.

What internals are you gonna install? Inquiring minds want to know...

This sounds like an interesting project, since the base gun is fairly inexpensive....and I always want to want a new gun. :D

.....

I left that to the one doing the work. He knows what's best, I'm just an end user. I'll find out and report back after I get it back with the parts listed as replaced.

Thanks a lot Brownie! Now I want one of these. Well, there goes the bank account. Lol

I spoke with the gunsmith about listing who he was, he's in Fla and on this site.

RickMcC, might want to check with him on makers of parts and works he's doing for me. He's also going to bevel the extractor for more positive feeding. Should be a race car inside and look like a mutt on the outside.

Upgrades to the pistol will include:

Harrison Custom Retro Extreme Service (HC ES) Ignition Set (hammer, sear and disco)

HC ES hammer strut and strut pin

HC ES short trigger

Colt LW sear spring; set to 4 1/4 - 4 1/2 pound trigger pull

Wolff plunger spring

Stone trigger track in frame

Radius bottom of extractor, check/set tension

Polish series 80 levers and plunger as necessary

Check thumb safety/plunger interface geometry and recut/polish as necessary

Please note: No, I'm not in business, or looking for any work!

Thanks Rick, really looking forward to seeing the results of the upgrades once it's back in Az.

:D No problem...