|
|
| Register | Forums | Blogs | Search | Today's Posts | Mark Forums Read | Donate |
 |
 |
 |
|
|
|
#1
09-05-2016, 11:57 PM
|
||||
|
||||
The RCBS die setup on the 550 is basically the same as it is on the Rock Chucker and other presses. While I screw the die into the Rock Chucker roughly 1/4 turn past shell plate contact, with the 550, I set it to just touch the shell plate.
Here's a link to the instructions in case you don't have them: http://www.rcbs.com/RCBS/media/RCBSM...structions.pdf
__________________
COTEP #CBOB0353 Happiness is a warm, dirty gun. Last edited by Grizzman; 09-06-2016 at 12:57 AM. 
|
|
#3
09-07-2016, 10:40 PM
|
||||
|
||||
|
I see that you've received your additional info in the other thread. Screwing the bullet seating die in until it touches the case mouth, then backing it off by a full turn is the correct answer.
I personally put a light crimp on rifle cases, in die station 4. It's not necessary, but I belong to the better safe than sorry crowd.
__________________
COTEP #CBOB0353 Happiness is a warm, dirty gun.
|
 |
| Thread Tools | |
| Display Modes | |
Hybrid Mode