![]() |
|
Register | Forums | Blogs | Search | Today's Posts | Mark Forums Read | Donate |
![]() |
![]() |
![]() |
#11
|
|||||
|
|||||
![]() Quote:
A wise old proverb says: Quote:
Ladies and Gentlemen, the finished product.... | | | | | V ![]() Left side ![]() Right Side. As you can see I was able to fit the HG and get everything right. But we are far from over. Now it has to be tested. And, already there has been one test failure. When I attempted to test it with dummy rounds (snap caps), the BCG got stuck when I tried to extract. I had to take it apart, manually pull back the BCG and get the dummy round out. I guess the only way I'll be able to test it is with live rounds. At least the dummy round did load from the mag and went into battery. Thank you all for working with me on this. I have learned much. And I do feel a lot more confident in my building skils. You just have to know certain tricks to get things to work The "Liquid Wrench" was a good trick for stubborn roll pins. Placing the HG on required me to remove the gas block/tube assembly... but ever so slightly so that the tube stays aligned in the delta ring and I can depress the delta ring and lock in the HG. then I can push the cap onto the guard and set the block on the barrel. I'll keep you posted once I test fire it. Well... I hope I can report to you and am not blown to bits.... ![]() ![]() Thanks again. Oh, and PS.... In re: my issue with the Gunbroker seller, while he did not answer his phone, I did send him a direct email and attached the updated copy of my FFL's cert doc. Within 1hr, I noticed that the FFL doc flag on the order was switched to "Received." So, although he may not be talking, he could very well be shipping. We'll see. ![]() Last edited by FfNJGTFO; 01-11-2021 at 02:50 PM. |
Thread Tools | |
Display Modes | |