COTEP.org  

Go Back   COTEP.org > Main Category > The Dremel Room

Reply
 
Thread Tools Display Modes
  #1  
Old 05-02-2013, 08:37 AM
Grouse Grouse is offline
Founding Member
COTEP Member
 
Join Date: Apr 2011
Posts: 1,490
Thanks: 82
Thanked 75 Times in 28 Posts
Default

another for dave severns. He has my vbob and is replacing the sights, crowning the barrell and hard hatting it, a cz82, and sig 226 slide.
__________________
I am MR. Shiggles and Gits
Reply With Quote
  #2  
Old 05-02-2013, 10:50 AM
Sheepdog's Avatar
Sheepdog Sheepdog is offline
Founding Member
Super Moderator
 
Join Date: Apr 2011
Location: Mason, Texas
Posts: 3,494
Thanks: 302
Thanked 357 Times in 75 Posts
Default

Sending it to Keith at DW or Dave Severns is going to take a while. This is the front sight Dave put on my CBOB.

__________________
canis fidelis cave canem, vereor non magnus nocens lupus

In hoc signo vinces

If you can list them, you ain't got enough!!!

Life Member NRA, SCI, ATA, NSCA
COTEP 414
Reply With Quote
  #3  
Old 05-02-2013, 12:18 PM
Jubz's Avatar
Jubz Jubz is offline
COTEP Member
 
Join Date: Feb 2013
Location: SoCal
Posts: 68
Thanks: 3
Thanked 15 Times in 2 Posts
Default

Thanks all for the info.

Sent an email to DW and Keith responded in minutes. The front sight roll pin is 1/6" x 3/16" and he's sending me one. He also recommended red Loctite applied to the front sight base. I've got the right hammer and pin punch, so easy enough to tap it in.

DW, great folks over there. Now if I can just get me a Valor out here in CA to continue supporting DW ...
__________________
DW CBOB
Reply With Quote
  #4  
Old 05-15-2013, 03:22 AM
Jubz's Avatar
Jubz Jubz is offline
COTEP Member
 
Join Date: Feb 2013
Location: SoCal
Posts: 68
Thanks: 3
Thanked 15 Times in 2 Posts
Default

Got the roll pin from Keith. Lined up the sight, and tapped in the pin with a 1/16" roll pin punch, and now I'm gtg. Thanks all!
__________________
DW CBOB
Reply With Quote
Reply

Thread Tools
Display Modes



All times are GMT -4. The time now is 05:31 PM.


Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.