|
|
| Register | Forums | Blogs | Today's Posts | Search | Donate |
 |
 |
 |
|
#12
05-09-2017, 03:30 PM
|
|||||
|
|||||
I got the Harbor Freight drill Press, where we are moving to would be a bit of a drive to HF so one more box to take up. Only thing left is really the 1/4" endmill and a stop collar as I have some good drill bits or can get those easily enough. I have seen mentioned that WD40 works for cutting fluid, can anyone confirm this? I wouldn't mind ordering it and having the endmill when we get up there. My wife has training in Dallas for a week for the new job so I would have some time to mill it without bothering her.
I will put a new thread up when I actually start the steps. If anyone has any suggestions for the endmill I would love to hear them.
__________________
CBOB0746 NRA Life Member Florida CWL Since 1992 
|
Threaded Mode