![]() |
|
Register | Forums | Blogs | Today's Posts | Search | Donate |
![]() |
![]() |
![]() |
|
#1
|
|||||
|
|||||
![]() Quote:
Fitting a steel slide to an already fit up alloy frame is a challenge. I can't just lap the two pieces together (the alloy frame is anodized and fit to the DW slide so I don't want to screw that up). So ... I am using a sacrificial stainless frame (I happen to have one hanging around) to fit and lap. It is almost there. I have the barrel fit to the slide and now just have to mill the slide to accept the reverse plug. It's been fun! ![]()
__________________
Mike Addicted to Pulling the Trigger! ![]() COTEP No. 0265 ![]() |
#2
|
|||||
|
|||||
![]() Quote:
Can you post images when you are finished? Good Luck!
__________________
NRA-LIFE,COTEP, USPSA,STEEL CHALLENGE,SASS,GSSF, ICORE GLOCK Certified Armorer |
#3
|
|||||
|
|||||
![]() Quote:
Maybe I will start a new thread and detail the progress ... slow as it is!
__________________
Mike Addicted to Pulling the Trigger! ![]() COTEP No. 0265 ![]() |